Written by : Nick
29-05-2024
Repairing an Old Swing Gate with Centurion Vector Motor
Yesterday, I worked on repairing an old metal single swing gate with a Centurion Vector motor. The motor is quite old, installed ten years ago. Due to the wet climate in New Zealand, the encoder tends to corrode, causing motor issues.
Motor Comparison:
The old Vector motor has an encoder board that tends to corrode in wet climates. The newer Vantage model has a better sealed casing, preventing such issues. Both motors are noisy and can be difficult to move manually, especially with a light gate.
Gate Post Issue:
The gate post had started leaning, causing the gate to get stuck on the ground. The customer had switched the gate to manual mode and turned off the power six months ago, causing the backup battery to go flat.
Battery Replacement:
The Centurion motor actually runs on battery power all the time, not just as a backup in case of a power cut. I replaced the battery and ensured that the controller was working correctly.
Gate Lifting:
To lift the gate, I needed to increase the distance between the bottom hinge and gate frame. By swapping the hinges and adjusting the top hinge bolt, I was able to lift the gate off the ground.
Magnetic Lock Adjustment:
After lifting the gate, I noticed that the magnet and magnet plate didn’t match. I turned around the magnet plate and shifted the lock to make the magnetic lock work properly.
Reprogramming and Testing:
I reprogrammed the gate and checked all functions. The gate no longer dragged on the ground and was able to close properly with the magnetic lock working correctly.
Conclusion:
If you’re experiencing issues with your gate or automation, don’t hesitate to contact Sesame Gate professionals. We have the expertise to diagnose and repair any problems with your gate system.
Repairing an Old Swing Gate with Centurion Vector Motor